tangyin blog

Do you know the T300 key programmer? Do you know well how to operate it? Below is something that you have to pay attention to when using this T300 key programmer vag manual, please read it carefully.

T300 key programmer Remote control programming 1997 on
Procedure
1.Switch Ignition ON and leave the key in the ignition.
2.Mechanically lock the vehicle using the Drivers door using a second key
3.Using the remote control press the unlock button once, and the horn will sound once.
4.Wait 6 seconds and press the unlock button once to activate the coding procedure. The remote control will now be programmed.
Note: when performing programming on additional remotes the procedure is the same, except you press the unlock button 2,3 or 4 times for the different remote.
Fore example: if you programming 2 remotes press the unlock button twice with a 1 second interval between each press, repeat for 3 and 4 remotes.

5. Switch Ignition OFF.
6. Remove key from ignition and check for operation
7.The coding procedure can be repeated up to 4 times for additional remotes.
8.The ignition must be switch OFF between programming each remote control.
Remote control erasing 1997 on
Procedure
1.Switch Ignition ON and leave the key in the ignition.
2.Mechanically lock the vehicle using the Divers door using a second key
3.Press the remote control lock button 5 times in a second intervals. A short horn will sound
4. Wait 6 seconds and press the unlock button once to activate memory erase
5.Switch ignition OFF, all remotes are now erase

Do you have a clear idea about the T300 key programmer? Sources from www.professional-diagnostic-tool.com

If there is question, please email/msn: pdtservice@hotmail.com